0.9 Power Factor High Frequency Single Phase Online UPS for Data
Center
Typical application
Data centre, bank station, network , communication equipment,
office, automatic equipment,
monitor equipment, control system
Excellent flexibility & Strong extendable capacity
1.Battery voltage can be choice depend on capacity
2.Convinence to get longer back up time and lower system invests
3.Convenience to save cost of battery
4.Intelligent battery monitors system and Charge current can be
adjust
5.Standant charge current 4A
6.Support more discharge time and more capacity battery for 8A
charger Input topology design
7.Support three phase input or single phase input for three phase
UPS
8.Super wide input voltage and frequency range suitable for bad
power electirc environment
9.Digital control DSP technology and best power component make the
system safe and reliable
Friendly design & Advanced parallel technology
1.Stable parallel control technology make sure current sharing to
1%
2.Select trip technology can avoid and isolation system fault then
improved system availability
3.Flexible extension capacity and redundance management that can
satisfy all kinds of requirements
4.Support maximum 3 units for parallel working Flexible strategy
5.On line mode provides higher system availability
6.High efficiency mode provides more economic operation
7.Frequency conversion provides more stable output
Muilti-function &Higher power factor to take more loads
1.Output power factor is 0.9 that mean can take more load, if you
take same load that can get higher reliability.Input power factors
up to 0.99
2.Three phase input model support three phase PFC , input
THDI<5%
3.Output voltage regulation 1%, frequency regulation 0.1%, parallel
current sharing 1%.
The efficiency up to 94%
4.Efficiency up to 93.5%when take the 30%load
5.ECO mode efficiency up to 98%
Technical Parameters
| Model | HP9116C PLUS 1-3KVA |
| 1KT | 1KT-XL | 2KT | 2KT-XL | 3KT | 3KT-XL |
| Rated Power | 1KVA/0.9KW | 2KVA/1.8KW | 3KVA/2.7KW |
| Rated Voltage | 220/230/240VAC |
| Rated Frequency | 40-70HZ |
| Input |
| Voltage Range | 115~300VAC |
| THDi | <10% |
| Power Factor | >0.98 |
| Output |
| Voltage Regulation | 220±2%VAC |
| Frequency Regulation | 50/60 Hz±0.05Hz |
| Power Factor | 0.9 |
| Voltage Distortion | Linear load＜4％ Non-linear load＜7％ |
| Overload Capability | 110%~150% for 47-25 sec；150% ~200% for 25-300ms;>200% for 200m |
| Current Crest Ratio | 3∶1 |
| Transfer Time | 0ms (AC mode→Battery mode) |
| Efficiency(on line mode) | >89% | >90% | >90% |
| Battery |
| DC Voltage | 24VDC | 36VDC | 48VDC | 72VDC | 72VDC | 96VDC |
| Recharge Time | 7 hours to 90% of capacity |
| Recharge Current | 1A | 6A | 1A | 6A | 1A | 6A |
| Display |
| LCD | Display input/output Voltage, Frequency, Battery voltage, Battery
capacity, Loading rate. |
| Communication |
| Interface | Smart RS232, SNMP card (Optional),USB (Optional) |
| Environment |
| Operation Temperature | 0~40℃ |
| Humidity | 20~90% (Non-condensing) |
| Storage Temperature | -25℃~55℃ |
| Sea Level Elevation | ＜1500m |
| Noise Level (1m) | ＜45dB | <50dB |
| Physics Characteristic |
| Dimensions: Wx D x H )mm | 145X345X229 | 192X393X328 |
